솔루션
솔루션 찾기 & FAQ
May 3, 2023
Graphics Cards Anti-sag Bracket Compatibility Notice (8cm)
To ensure the best fit for the anti-sag bracket, please make sure your components are within the specs below:
- The system chassis supports the mounting of ATX size motherboards or above.
- The area around the screws (the two bottom right most screws on the ATX motherboard) of the anti-sag bracket is not covered or blocked by any peripheral components (e.g. front panel USB type-C, SATA…).
- There are at least 8 cm of clearance from the chassis' front panel to the right-center screw lock point of the anti-sag bracket, and 0.5 cm of clearance from the backside of the chassis to the anti-sag bracket, to ensure there are enough room for installation
- The PCIe slot must be slightly below the bracket's arm (Typically the second PCI slot for standard ATX motherboard).
