To ensure the best fit for the anti-sag bracket, please make sure your components are within the specs below:

1. The system chassis supports the mounting of ATX size motherboards or above.
2. The area around the screws (the two bottom right most screws on the ATX motherboard) of the anti-sag bracket is not covered or blocked by any peripheral components (e.g. front panel USB type-C, SATA…).
3. There is at least 14 cm of clearance from the chassis' front panel to the right-center screw lock point of the anti-sag bracket, and 0.5 cm of clearance from the backside of the chassis to the anti-sag bracket, to ensure there are enough room for installation
4. The PCIe slot must be slightly below the bracket's arm (Typically the second PCI slot for standard ATX motherboard).

*The images below are for reference only. The actual anti-sag brackets and motherboard may vary slightly by model.